2-58 Installation
2.7 System Restart
If after checking the system features you determine that the system
is not operating properly, restart the system.
Keep in mind that the following features are cleared when you
restart the system:
• Camp-on
• Call Park
The following features are cancelled when you restart the system:
• Calls on Hold
• Calls on Exclusive Hold
• Calls in progress
1. Make sure that the system clear switch is set to “NORMAL.”
2. Press the Reset button with a pointed tool.
Notice If the system clear switch is set to “CLEAR,” do not slide the system
clear switch to “NORMAL” within 20 seconds of pressing the Reset
button. If you do, the system programming data is reset to the default
values. (Refer to Section 2.8 “System Data Clear.”) Wait over 30 seconds
after pressing the Reset button and then slide the system clear switch to
“NORMAL.”
If the system still does not operate properly, please see Section 6.1.4
“Using Reset Button.”
To Next Page
Loading...
Need help?
General
