4.6 CO Line Programming
DID Incoming Assignment
431
System Programming 4-103
Description Assigns DID incoming method, immediate or wink, to each DID
table in accordance with the service of your central office.
Immediate: Incoming DID call can be received right after
receiving signal arrives.
Wink: Incoming DID call can be received after the wink signal is
transmitted to the central office (after receiving signal arrives).
Selection • DID table number: 1 through 4, ( =all DID tables)
• Immediate / Wink
Default All DID tables – Wink
Programming 1. Enter 431.
Display: DID In Asn
2. Press NEXT.
Display: DID Table NO?–>
3. Enter a DID table number.
To enter DID table number 1, you can also press NEXT.
Display example: 1:Wink
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another DID table, press NEXT or PREV, or
SELECT and the desired DID table number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions To assign all DID tables to one selection, press the key at step 3. In
this case, the display shows the contents programmed for DID table
number 1.
Feature References Section 3, Features,
Direct Inward Dialing (DID)
To Next Page
Loading...
Need help?
General
