4.4 Timer Programming
Inter Digit Time
208
4-64 System Programming
Description Assigns the maximum time allowed between digits on an outgoing
toll call. If an extension user fails to dial any digits during this
time, the DTMF receiver is released. This timer applies until the
Toll Restriction check is completed.
Selection Time (seconds): 5 through 30
Default 10 s
Programming 1. Enter 208.
Display: Inter Digit Time
2. Press NEXT.
Display example: Time:10 sec
3. Enter the time.
To change the current entry, press CLEAR and the new time.
4. Press STORE.
5. Press END.
Conditions • This timer is used for toll restriction checking.
• You cannot leave the entry empty.
Feature References Section 3, Features,
Toll Restriction
To Next Page
Loading...
Need help?
General
