4.2 Manager Programming
System Speed Dialing Number Set
001
System Programming 4-17
Description Used to program the System Speed Dial numbers. These numbers
are available to all extension users. There are 500 numbers from
000 through 499.
Selection • Speed dial number: 000 through 499
• Telephone number: 24 digits (max.)
Default All speed dial numbers – Not stored
Programming 1. Enter 001.
Display: SPD Number Set
2. Press NEXT.
Display: SPD Code?—>
3. Enter a speed dial number.
To enter speed dial number 000, you can also press NEXT.
Display example: 000: Not Stored
4. Enter a telephone number.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new number.
5. Press STORE.
6. To program another speed dial number, press NEXT or
PREV, or SELECT and the desired speed dial number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • There is a maximum of 500 speed dial numbers. Each speed dial
number has a maximum of 24 digits. The valid characters are 0
through 9, , and # keys, RECALL, PAUSE, SECRET and –
(hyphen) buttons.
– To store the register recall signal, press RECALL.
Note: The stored recall will be in effect only during an
established call. (Refer to Section 3 “External Feature
Access.”)
– To store a hyphen, press the “–” button.
To Next Page
Loading...
Need help?
General
