System Programming 4-13
4.1.5 Example of Programming
Description
(4)
Used to program the System Speed
Dial numbers. These numbers are
available to all extension users. There
are 500 numbers from 000 through 499.
Selection
(5)
• Speed dial number: 000 through 499
• Telephone number: 24 digits (max.)
Default
(6)
All speed dial numbers – Not stored
Programming
(7)
1. Enter 001.
(8)
Display: SPD Number Set
(9)
2. Press NEXT.
(10)
Display: SPD Code?->
(11)
3. Enter a speed dial number.
To enter speed dial number 000,
you can also press NEXT.
Display example: 000:Not
Stored
(12)
4. Enter a telephone number.
(13)
To delete the current entry, press
CLEAR.
(14)
To change the current entry, press
CLEAR and the new number.
5. Press STORE.
(15)
6. To program another speed dial
number, press NEXT or PREV,
or SELECT and the desired
speed dial number.
(16)
7. Repeat steps 4 through 6.
(17)
8. Press END.
(18)
Conditions
(19)
• There is a maximum of 500 speed
dial numbers. Each speed dial
System Speed Dialing Number Set
(
3)
4.2 Manager Programming
(2)
001
(1)
(1) Program address: This address is printed at the top
of every page to allow you to quickly find the
desired program.
(2) Running title: tells you which group the program
belongs to.
(3) Program title.
(4) Provides a more detailed description of the
program.
(5) Shows you choices that you can assign.
(6) Shows you the default (factory setting).
(7) Shows you programming procedures step by step.
• While programming, use the overlay.
• Before starting to program, enter the
programming mode. (See “Entering the
programming mode” on page 4-6.)
(8) Enter the program address.
(9) The display shows the program title. If your
telephone has soft buttons, the lower line shows
the functions that are currently assigned to them.
(10) Press either Soft 3
(NEXT)
shown on the display
or the NEXT shown on the overlay.
(11) The message line advises you to enter a speed dial
number.
(12) If the telephone number has already been stored,
the number is displayed.
(13) Enter the telephone number that you want to store.
Your entry is displayed as you enter the digits.
(14) Pressing CLEAR erases the whole entry.
(15) Your entry is now stored.
The indicator lights red and confirmation tone lets
you know that the storage is completed.
(16) Select the best way for you to store another speed
dial number. Pressing the NEXT / PREV allows
you to select the next higher / lower speed dial
number. You can also keep pressing them until the
desired one is displayed. If you press SELECT
Sample of Description Explanation
The following programming instructions suppose that you have
already entered programming mode and that you will employ
method (2) on page 4-8.
Example: Program [001] “System Speed Dialing Number Set”
To Next Page
Loading...
Need help?
General
