4.5 TRS / ARS Programming
ARS Leading Digit Entry for Plans 1 through 8
314-321
4-76 System Programming
Description By entering numbers into each leading digit plan (programs below)
you are starting the process to determine which CO line group will
be used to route the call.
Program: [314] [315] [316] [317] [318] [319] [320] [321]
Plan: 1 2 3 4 5 6 7 8
These eight plans are used to analyze the number which the user
dials and to decide the route plan for the call. If the user-dialed
number is registered in plan 1, then Routing Plan 1 is selected for
the call. ARS Leading Digit Entry for Plans 1 through 8 match
ARS Routing Plans 1 through 8 (programs [322] through [329])
respectively.
Selection
• Location number: 01 through 50
• Leading digit number: 7 digits (max.)
Default All locations – Not stored
Programming 1. Enter a program address (314 through 321).
Display example: ARS Leading PL-1
2. Press NEXT.
Display: Location NO?->
3. Enter a location number.
To enter location number 01, you can also press NEXT.
Display example: 01:Not Stored
4. Enter a leading digit number.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new number.
5. Press STORE.
6. To program another location, press NEXT or PREV, or
SELECT and the desired location number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions There is a maximum of 50 leading digit numbers for each plan. Each
number has a maximum of seven digits, consisting of 0 through 9, and
. The character “ ” can be used as a wild card character.
Feature References Section 3, Features,
Automatic Route Selection (ARS)
To Next Page
Loading...
Need help?
General
