4.6 CO Line Programming
DID Outgoing Assignment
432
4-104 System Programming
Description Assigns DID outgoing method, immediate or wink, to each DID
table in accordance with the service of your central office.
Immediate: Outgoing DID number can be transmitted right after
seizing the CO line.
Wink: Outgoing DID number can be transmitted after receiving the
wink signal from the central office after seizing the CO line.
Selection • DID table number: 1 through 4, ( =all DID tables)
• Immediate / Wink
Default All DID tables – Wink
Programming 1. Enter 432.
Display: DID Out Asn
2. Press NEXT.
Display: DID Table NO?–>
3. Enter a DID table number.
To enter DID table number 1, you can also press NEXT.
Display example: 1:Wink
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another DID table, press NEXT or PREV, or
SELECT and the desired DID table number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • The time the system waits for the confirmation wink signal can be
programmed in program [435] “DID Wink Time Out Assignment.”
The system disconnects the CO line when the time-out time expires.
• To assign all DID tables to one selection, press the key at step 3. In
this case, the display shows the contents programmed for DID table
number 1.
Feature References Section 3, Features,
Direct Inward Dialing (DID)
To Next Page
Loading...
Need help?
General
