4.2 Manager Programming
System Speed Dialing Name Set
002
System Programming 4-19
Description Assigns names to the system speed dial numbers assigned in
program [001] “System Speed Dialing Number Set.” The large
display telephone (KX-T7235) shows the stored name when
performing System Speed Dialing.
Selection • Speed dial number: 000 through 499
• Name: 10 characters (max.)
Default All speed dial numbers – Not stored
Programming 1. Enter 002.
Display: SPD Name Set
2. Press NEXT.
Display: SPD Code?—>
3. Enter a speed dial number.
To enter speed dial number 000, you can also press NEXT.
Display example: 000: Not Stored
4. Enter a name.
For entering characters, see Section 4.1.3 “Entering Characters.”
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new name
5. Press STORE.
6. To program another speed dial number, press NEXT or
PREV, or SELECT and the desired speed dial number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • Speed dial numbers are programmed in program [001] “System Speed
Dialing Number Set.”
• There is a maximum of 500 names. Each name has a maximum of 10
characters.
• The stored names are applied to the CO Incoming Call Information
Display / Log feature.
• To go to another speed dial number at steps 3 through 6, press
SELECT and start with step 3.
Feature References Section 3, Features,
Special Display Features for KX-T7235 — System Speed Dialing
To Next Page
Loading...
Need help?
General
