Measurement setups Measurement Snapshot control window
Measurement Snapshot control window
From the Measure menu, select Measurement Snapshot.
Overview
Measurement Snapshot lists all o f the automated measurements that are available for a selected waveform.
To use
1. Select the waveform for which you want to take a snapshot.
2. Click the Snapshot button in the Measurement control window, or select Snapshot from the Measure
menu.
3. Click either General or Comm in the Snapshot Type group box to begin the snapshot.
Behavior
When the instrument has completed all of the m easurements, the snapshot window is updated with the
measurements.
Measurement Snapshot executes all of the single waveform measurements once; the measurements are not
continuously updated. Any measurements previously taken are retained on the display until you complete
a new snapsho
t. To take another snapshot, click the Refresh button.
NOTE. Automatic measurements are not available on digital channels.
TIP. Befor
e taking a snapshot, be sure to properly display the waveform. Measurement Snapshot does
not warn you if a waveform is improperly scaled (for example, clipped, low signal amplitude, low
resolution, and so on).
DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series 267
To Next Page
Loading...
Need help?
General
