Analyzing waveforms Set up FLEXRAY s earch parameters
Set up FLEXRAY search parameters
After setting up an FLEXRAY bus, go to the Analyze menu, select Search, and then select the Bus trigger
type; then open the Configure tab.
Overview
Use the cont
rols to set up the FLEXRAY Bus parameters.
To use
For information o n the controls, click the buttons.
Behavior
Clicking an entry in the Type column activates the individual search controls, similar to the one shown
above. These controls vary depending on the search Type. Setting the search conditions is similar to
setting the parameters for an Event Trigger
(see page 386).
NOTE. No information will be displayed in this window until you specify at least one search Type in
the Search Select Control Window
(see page 300).
To use
Click the Source box and select the bus number or name from the window. Bus Search Selection
List (see page 98)
Select the type of bus cycle o r activity to search for from the Search For drop-down list.
For some Search For selections, you must set additional fields to define other parameters such as for
Data.
DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series 353
To Next Page
Loading...
Need help?
General
