Oscilloscope Reference Burst width
Burst width
This timing measurement is the duration of a burst (a series of transient events) and is measured over
the entire waveform or g ated region.
CAN bit rate
1. Click in the Nominal Bit Rate entry box.
2. Use the multipurpose knob to set the bit rate for the trigger.
CAN format
In the CAN Format drop-down list, specify the format.
CAN signal type
In the drop-down Signal Type list, select the type of data to trigger on.
Cent
er frequency
The c
enter frequency is the frequency at the center of the frequency span. The maximum center frequency
is equal to the sample rate divided by two (the Nyquist frequency) minus one half the span. The minimum
center frequency is equal to one h alf of the span.
If the frequency span is set to maximum, then the center frequency will not move. To increase the c enter
frequency beyond the present limits, either reduce the frequency span or increase the sample rate. To
decrease the center frequency beyond the present limits, reduce the frequency span.
DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series 793
To Next Page
Loading...
Need help?
General
