Vertical Setups Set up Vertical controls
Set up Vertical controls
From the Vertical menu, select Vertical Setup.
Overview
Use the Vertical Setup control windows to set vertical parameters for live (channel) waveforms. The
example windows below do not show controls for attached probes.
Click for <4 GHz instruments Click for ≥4 GHz instruments
xxx
For information on the Vertical Setup controls, click the buttons.
NOTE. iCapture is available only on MSO70000C Series instruments.
Termination Voltage is available only on DSA/DPO70000D Series instruments.
NOTE. The bandwidth readout displays in reverse video if the bandwidth is not what you selected. If you
want the bandwidth to be what you selected, make sure that the sample rate is high enough to enable
Digital Filters (DSP). One way to enable DSP is to select Force Constant Sample Rate.
NOTE. The features and options that are documented in this online help are available for several
instrument models. Your instrument may not have every feature discussed in this online help.
To use
Use the tabs on the side of the control window to select the channel you want to change. The controls for
each channel are independent.
What do you want to do next?
Continue to learn about the Vertical Setup controls. (see page 951)
Set up input channels
NOTE. iCapture is available only on MSO70000C Series instruments.
DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series 481
To Next Page
Loading...
Need help?
General
