Cursor setups Cursor type control window
Learn about Cursor Readouts in XY display format. (see page 75)
Cursor type control w indow
From the Cursor menu, select Cursor Controls, or press the front panel Cursors button.
Overview
Use the Cursor Type control window to select the source for each cursor and the type of cursors used
for waveform measurements.
For information o n the controls, click the buttons.
To use
1. Click the Source drop-down list to select the source for the cursor.
2. Click one of the Cursor Type buttons to select a cursor type.
TIP. Select a cursor type directly from the Cursors menu Cursor Type submenu.
Behavior
If you are using H-Bar or V-Bar Cursors, and want to measure the same waveform with both cursors,
select the waveform for Cursor 1. Cursor 2 will have the same value as Cursor 1, unless you change it.
Click Setup to open the Cursor control window where you can specify other cursor parameters.
What do you want to do next?
Learn about the Cursor Position controls. (see page 77)
L
earn about the Cursor Setup controls.
(see page 71)
DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series 73
To Next Page
Loading...
Need help?
General
