Analyzing waveforms Set up CAN search parameters
Behavior
Clicking an entry in the Type column activates the individual search controls, similar to the one shown
above. These controls vary depending on the search Type. Setting the search conditions is similar to
setting the parameters for an Event Trigger
(see page 386).
NOTE. No information will be displayed in this window until you specify at least one search Type in
the Search Select Control Window
(see page 300).
To use
Click the Source box and select the bus number or name from the window. Bus Search Selection
List (see page 98)
Select the type of bus cycle or a ctivity to search for from the Search For drop-down list.
For some Search For selections, you must set additional fields to define other parameters such
as for Ident & Data.
In this example, you need to set an Identifier, Direction, Data is, and Data value (click the Edit
(see
page 939) button). O ptionally, you can also set the component threshold levels through the Logic
Thresholds Setup button.
346 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series
To Next Page
Loading...
Need help?
General
