Copying and Printing Copy Setup: Waveforms
To use
The Data Destination (data format) is Spreadshe et only.
Selec
t a valid waveform from the Source list.
Select the number of samples you want to copy. Select All samples, a range of samples, or only
the s
amples between the cursors. If you select Save Samples between Cursors, you can use the
multipurpose knobs to adjust the positions if the cursors are already active. If they are not, the cursors
will be turned on at the positions they were in the last time they were used.
Select the Include waveform scale factors check box if you want to include waveform details, such a s
header information (record length, sample interval, trigger point information, and s o on). If you only
want to include the waveform voltage values, clear the selection.
Specify the FastFrame Data Range if you are copying FastFrame data.
If you are copying Fast Acquisition data, select the data ordering from the list.
DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series 515
To Next Page
Loading...
Need help?
General
