Installation and Maintenance Manual - Aastra 5000 AMT/PTD/PBX/0058/4/6/EN
Description des sous-ensembles 01/2011 Page 145
4.3.2.1 Indicators
The UCV-D card has 8 indicators plus the ones integrated in the LAN connection. An
indicator may contain several LEDs
:
Note: The "OP" and "ACT" indicators are useful in a duplex configuration. In a simplex
configuration, these indicators are always on (green) when the card is
operational.
INDICATOR STATE EXPLANATION
EIP No.1 ON green Activity on Ethernet link: EIP daughter card No.1
EIP No. 2 ON green Activity on Ethernet link: EIP daughter card No.2
SHTD (red)
Linux shutdown
Red flashing
ON green
Off
PBX shutting down after the SHTD button has been pressed, or
following a Reset OS or Reboot OS request by MMC (do not power
off the device).
Power off authorisation
Normal operation.
DISK ON green Disk is being used
RUN (green) On steady
Off
Flashing
ON upon card reset and during OS restart.
OFF during application start.
Flashing when the application is operational.
DPLX (green) Green flashing
ON green or OFF
Clock received from UCV-D
No clock (UCV stopped or cable disconnected)
LAN
2 LEDs integrated
in the RJ45
connector
- 1 yellow LED:
Off
On
Flashing
- 1 green/yellow LED:
Off
ON green
ON yellow
Half Duplex link.
Full Duplex link.
Collisions
Link not set up.
Link set up at 100 Mb/s.
Link set up at 10 Mb/s.
ACT ON green
Off
Card active
Card not active
OP ON green
ON red
Board operational
Card out of service
TABLEAU 4.6 OVERVIEW OF THE UCV-D CARD INDICATORS
To Next Page
Loading...
Need help?
General
