AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 390 01/2011 Installation and activation
4. Start the iPBX and configure:
- The IP address
- The software licence
- The countries and languages (the first two must be identical to those defined on the
previous card)
- The TMA, DHCP and FTP services, like on the previous card.
5. Start the data restore operation.
6. After restarting the cabinet, test the release then validate it if satisfactory.
7. Remove the USB key.
6.12.1 Migration process
6.12.1.1 Preliminary operations
For the backup or restore operation to be performed correctly, the system first checks:
• That a USB key is correctly connected and recognised
• That the active and inactive software releases have been validated
• That the automatic TMA related actions have been taken and fully completed
• That the available space on the USB key, in case of backup, or on the compact flash
card, in case of restore, is enough for the operation
In case of error, a dialogue box appears and the required operation is not performed.
The exchange directory created by the software is unique on the USB key. This is named
backup_CF.
Remarque :During backup and restore, it is not possible to access or leave messages on the IVB.
6.12.1.2 Backing up data on the USB key (1 GB recommended)
6.12.1.2.1Procedure
To perform the migration, first connect a USB key to the iPBX's CPU card before
accessing the menu SYSTEM/Software maintenance/Compact flash migration.
When this menu is selected, the software searches for the key and analyses its content.
The content of the target directory on the key is first deleted, if it exists, otherwise a target
directory is created if there is none.
If no key is detected, a message indicates that no key has been detected:
No USB key detected
On these conditions, connect a key then exit and return to the menu.
To Next Page
Loading...
Need help?
General
