Installation and Maintenance Manual - Aastra 5000 AMT/PTD/PBX/0058/4/6/EN
Installation and activation 01/2011 Page 355
6.3.4 Adding an equipment card (AXD, AXL, AXS, AXS12 and AXS6)
The iPBX can be fitted with one or more expansion cards to increase the system capacity.
In an iPBX, it is possible to install all types of expansion cards according to the existing
configuration and hardware configuration rules.
An equipment card can be hot-plugged in the main cabinet or expansion cabinet of an
iPBX.
CONTRAINTE
• Refer to section 3.5 to check the constraints imposed by the hardware configuration
rules.
• Check any particular installation and wiring details for the card to be added
(see Sections 4.6 to 4.14).
• The configuration data needs to be changed if the system is expanded. Before adding
new components, the data must be saved on hard disk or floppy.
• Immediately after installing and programming any new components, you should make
a second backup, to save the system's new configuration.
Procedure
• Check the compatibility between the card to be installed and its slot in the main or
expansion cabinet (see section3.5).
• Check that the cards fitted with configuration micro-switches are configured correctly
(see Sections 4.13 to 4.14).
• Remove the blanking plate:
- Turn the plate 1/4 turn locks by 1/4 turn (see Section 4.1).
- Remove the blanking plate from the slot where the card is to be installed
• Insert the card in the required slot and slide the card along the card guides until it clicks
into place.
• Lock the card in place using the 1/4 turn locks (see Section 4.1).
• Install the cables on the card’s front panel.
• Activate the card from the operating console.
• Program any additional lines or sets associated with the card.
• For a subscriber card, assign a directory number to each extension and put all the
extensions in service (see Section 1.3).
To Next Page
Loading...
Need help?
General
