EasyManuals Logo
Home>Aastra>Server>AXD

Aastra AXD User Manual

Aastra AXD
502 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #392 background imageLoading...
Page #392 background image
AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 392 01/2011 Installation and activation
6.12.1.3 Replacing the compact flash card
Stop the iPBX by respecting the following two phases:
• On the CPU card, press briefly the "SHTD" (Shutdown) button. Wait for the green
"SHTD" indicator light to be steady on, and for the other ones to go off.
• Power off the power modules (I/O push button on O).
Then
• Remover the CPU card from the cabinet.
• Remove the 1 GB compact flash card and replace it with a 2 GB flash card.
• The 2 GB compact flash card must be of the 2 GB loaded not started type so the
country and spoken languages can be defined using Ctrl + I.
• Place back the CPU card.
• Start the iPBX in Ctrl + i mode (see next section).
If the software release is below the previous one, upgrade the software (see the
document AMT/PTD/PBX/0058).
6.12.1.4 Restart with the new 2 GB card in TOTAL mode, using Ctrl + i.
Nota : For more information about the procedure, see the document AMT/PTD/
PBX0058, the section on changing from a 1 GB compact flash card to a 2 GB
compact flash card, and activating a new system.
During restart in TOTAL mode using CTRL + i, the following fields must be filled in (like in
the previous configuration):
• Network configuration (IP address, subnet mask and gateway)
• Country
• Languages (out of the five languages proposed, the first two must be the same as in
the previous configuration)
Important : During migration to a 2 GB compact flash card, 5 languages are proposed
whereas only 2 languages were proposed on the previous card. Therefore,
the first two languages defined on the 1 GB compact flash card must be used
on the new compact flash card.
• Licence
• Services (FTP, TMA and DHCP).
After restart, confirm the software release and perform an upgrade if there is a difference
between the new release installed on the 2 GB compact flash card and the release
contained in the backup.
In case of upgrade, it will be necessary to validate this new software release.
Then restore the previous configuration in the 1 GB compact flash card (see previous

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Aastra AXD and is the answer not in the manual?

Aastra AXD Specifications

General IconGeneral
BrandAastra
ModelAXD
CategoryServer
LanguageEnglish

Related product manuals