AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 326 01/2011 Installation and activation
VLAN ID and VLAN PORT: These parameters are used to define the VLAN dedicated to
terminals 67xxi, A53xxip and i7xx). They are not obligatory on simple networks.
The system then restarts automatically, and the its IP network link can be set up via the
LAN access.
Start-up is now complete and you can configure the site from the user interface. For
terminal management refer to the document [15].
Note : You can modify the factory settings completely, using the T mode after pressing Ctrl + I (see
Section 6.2.7).
To Next Page
Loading...
Need help?
General
