Telephone operation via the keypad
196
When the second call is accepted, the line to the second
caller is open immediately and the first call is put on hold.
You can then
>
Switch between the two calls (trade), see page 195
>
Create a conference call between yourself, the new
caller and the first caller, see page 195.
Rejecting a further call with a call already in
progress
If you do not wish to accept the second call:
Select this to reject the call.
Replacing current call
If you wish to terminate a current call in order to accept a
further call:
Select.
If you are already trading between two calls, the call
that is currently active rather than the one that is on
hold is substituted.
<
Diverting calls
Call diversion if not reachable
Incoming calls are only diverted to a determined number if
you cannot be reached when the caller phones. This is the
case e.g. if your telephone is switched off, you are momen-
tarily out of range e.g. when travelling through an under-
pass or tunnel, or are outside the area covered by the GSM
network.
Call up main menu
Divert 2
Select and confirm
If Not Reachble
Select and confirm.
Display shows:
Off
Select.
Display shows:
If Not Reachble
Please Enter
You can now directly enter the number to which calls are to
be diverted, e.g. your mailbox, see page 200, or select a
number from the phone book, see page 202.
To do this:
Press
Select an entry and confirm.
Display shows:
Status Stored
ba.book Page 196 Thursday, December 19, 2002 8:13 PM
To Next Page
Loading...
Need help?
General
