Fuji Xerox Phaser 5500 User Manual

3-86 Phaser 5500 Printer Service Manual
10
Check continuity between the Registration
Sensor and Engine Logic Board.
Is there continuity on each wire
between P/J104 <=> P/J403?
Go to Step 11. Repair the wiring.
11
Check for +5 V to the Registration Sensor.
Is there +5 V across P/J104-1 (+) <=>
ground?
Replace the
Registration
Sensor
(
page 8-52).
Replace the
Engine Logic
Board
(
page 8-89.
12
Test the Pick Up Solenoid operation.
Run the Service Diagnostics Tray 1 Feed
Solenoid test.
Does the Pick Up Solenoid operate
properly?
Replace the
Engine Logic
Board
(
page 8-89).
Go to Step 13.
13
Check the Pick Up Solenoid connection.
Are P/J205, P/J605 and P/J411
connected?
Go to Step 14. Connect P/J205,
P/J605 and P/
J411.
14
Check the Pick Up Solenoid continuity.
Is there continuity on each wire
between P/J205 <=> P/J411?
Go to Step 15. Repair the wiring.
15
Check the Pick Up Solenoid resistance.
Is the resistance across J205-1 and
J205-2 approximately 90 ohm?
Go to Step 16. Replace the Pick
Up Solenoid
(
page 8-36).
16
Check for +24 V to the Pick Up Solenoid.
Is there +24 V across P205-1 (+) <=>
ground?
Replace the Pick
Up Solenoid
(
page 8-36).
Replace the
Engine Logic
Board
(
page 8-89).
Jam at Tray 1/MPT (Registration Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No

Fuji Xerox Phaser 5500 Specifications

General

Brand	Fuji Xerox
Model	Phaser 5500
Category	Printer
Language	English