Fuji Xerox Phaser 5500 User Manual

Error Messages, Codes, and Procedures 3-223
Stacker Lower Tray Full - Finisher Mix Full Stack
The Stacker Encoder Sensor for the Stacker Lower Tray indicates a Stack Full
condition.
6
Check for +5 V to the Top Tray Full Sensor.
Is there +5 V across J8302A-12 <=>
J8302A-10 on the Finisher Main PWB?
Go to Step 7. Replace the
Finisher Main
PWB
(
page 3-248).
7
Check the Top Tray Full Sensor signal.
Does the voltage across P8302A-11 <=>
P8302A-10 on the Finisher Main PWB
change when the sensor is covered?
Replace the
Finisher Main
PWB
(
page 3-248).
Replace the
Upper Tray Full
sensor
(
page 3-233).
Lower Tray Full (Stack Encoder Sensor) Troubleshooting Reference
Applicable Parts References
■ Finisher Main
PWB
■ Main Sensor
Harness
■ Stacker Encoder
Sensor
■ Elevator Motor
■ Phaser 5500 Printer Options Service Manual
■ Finisher Main PWB P/J Locator (page 5-35)
■ Finisher Sensors (2/2) Wiring (page 5-41)
■ Finisher Clutch and Solenoids Wiring (page 5-43)
■ PL25.6 Finisher Stack (page 4-54)
■ PL25.14 Finisher Electrical (page 4-70)
■ PL25.15 Finisher Harness (page 4-72)
Lower Tray Full (Stack Encoder Sensor) Troubleshooting Procedure
Step Actions and Questions Yes No
1
Check the Stacker Lower Tray for
obstructions.
Are there any obstacles in the path of
the Stacker Lower Tray?
Remove the
obstacles.
Go to Step 2.
2
Check the Encoder wheel installation.
Does the Encoder rotate and enter the
sensing area of the Stacker Encode
Sensor?
Go to Step 3. Correct and go to
Step 3.
3
Test the Stacker Encoder Sensor.
Run the Service Diagnostics Stacker
Encode Sensor test.
Does the sensor state change when the
Elevator Motor Belt is moved by hand
rotating the Encoder Wheel?
Go to Step 9. Go to Step 4.
Upper Tray Full (Upper Tray Full Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No

Fuji Xerox Phaser 5500 Specifications

General

Brand	Fuji Xerox
Model	Phaser 5500
Category	Printer
Language	English