Fuji Xerox Phaser 5500 User Manual

3-144 Phaser 5500 Printer Service Manual
Tray 6 Failure - H1-5 Tray 6 Fail
Detected lift failure or paper size detection inoperative.
Applicable Error Code
Tray 6 Failure - H1-5 Tray 6 Fail
Tray 6 Failure Troubleshooting Reference
Applicable Parts References
■ Tray In Se n so r
■ Tray 6 Main Harness
■ Tray 6 Feeder
Harness
■ Tray 6 PW B
■ Lift Cables
■ Feed/Lift Motor
■ Nudger Solenoid
■ Level Sensor
■ Engine Logic Board.
■ Print Engine P/J Engine Logic Board (page 10-13)
■ PL2.1 Tray (1/2) and Feeder (1/2) (page 9-8)
■ PL2.2 Tray (2/2) (page 9-10)
■ PL2.3 Feeder (2/2) (page 9-12)
■ PL8.1 Print Engine Electrical (page 9-40)
■ Phaser 5500 Printer Options Service Manual
■ 2000-Sheet Tray 6 Feeder P/J Locator (page 5-20)
■ 2000-Sheet Tray 6 Drive P/J Locator (page 5-21)
■ 2000-Sheet Tray 6 Sensors Wiring (page 5-24)
■ 2000-Sheet Tray 6 Drive Wiring (page 5-25)
■ PL22.1 Tray 6 Covers (page 4-18)
■ PL23.3 Tray (2/2) (page 4-20)
■ PL22.4 Tray 6 Feeder (1/3) (page 4-24)
■ PL22.5 Tray 6 Feeder (2/3) (page 4-26)
■ PL22.8 Tray 6 Electrical (page 4-32)
Tray 6 Failure Troubleshooting Procedure
Step Actions and Questions Yes No
1
Check Tray In Sensor alignment.
Pull the Tray out.
Does the actuator enter the sensing
area of the Tray Set Sensor, or is it
deformed or damaged?
Go to Step 2. Repair the
damage and go
to Step 2.
2
Check the Tray installation.
Is the Tray installed correctly?
Go to Step 3. Correct and go to
Step 3.
3
Check the repairs.
Does the error reoccur?
Go to Step 4. Problem solved.
4
Test the Tray In Sensor.
Run the Service Diagnostics Tray In
Sensor test.
Does the sensor status change when
the tray is moved in and out?
Go to Step 10. Go to Step 5.
5
Check the Tray In Sensor Main Harness
connection.
Are PF53 and JF01 connected?
Go to Step 7. Connect and go
to Step 6.

Fuji Xerox Phaser 5500 Specifications

General

Brand	Fuji Xerox
Model	Phaser 5500
Category	Printer
Language	English