Fuji Xerox Phaser 5500 User Manual

3-232 Phaser 5500 Printer Service Manual
Punch Waste Box is Missing
The Punch Box Set Sensor indicates the Punch Box is not installed in the Finisher.
Punch Box Missing (Punch Box Set Sensor) Troubleshooting Reference
Applicable Parts References
■ Punch Box Set Sensor
■ Punch Box Sensor
Harness
■ Punch Sensor
Harness
■ Finisher Main PWB
■ Engine Logic Board.
■ Phaser 5500 Printer Options Service Manual
■ Finisher Main PWB P/J Locator (page 5-35)
■ Finisher Punch P/J Locator (page 5-31)
■ Finisher Punch (1/2) Wiring (page 5-46)
■ PL8.1 Print Engine Electrical (page 9-40)
■ PL25.7 Finisher Punch (page 4-56)
■ PL25.14 Finisher Electrical (page 4-70)
■ PL25.15 Finisher Harness (page 4-72)
Punch Box Missing (Punch Box Set Sensor) Troubleshooting Procedure
Step Actions and Questions Yes No
1
Test the Punch Box Set Sensor.
1. Open Door G.
2. Remove the Punch Box.
3. Run the Service Diagnostics Punch Box
Set Sensor test.
Does the sensor state change when the
Punch Box is removed and replaced?
Go to Step 8. Go to Step 2.
2
Check the harness connections.
Are P/J8353 and P/J8355 of the Punch
Box Sensor Harness, and P/J8355 and
P/J8307 of the Punch Sensor Harness
connected?
Go to Step 4. Connect and go
to Step 3.
3
Cycle the printer power.
Does the error still occur?
Go to Step 4. Problem solved.
4
Check Punch Box Sensor Harness
continuity.
1. Disconnect P/J8353 and P/J8355.
2. Check for continuity at the following:
J8353-3 <=> P8355-3
J8353-2 <=> P8355-2
J8353-1 <=> P8355-1
Are these conductive?
Go to Step 5. Repair the wiring.

Fuji Xerox Phaser 5500 Specifications

General

Brand	Fuji Xerox
Model	Phaser 5500
Category	Printer
Language	English