Fuji Xerox Phaser 5500 User Manual

3-176 Phaser 5500 Printer Service Manual
Stacker Lower Tray Failure - H5-8n Eject Clamp SNR
The Eject Clamp Home Sensor does not change state within the time interval
specified following the activation of the Eject Clamp.
Applicable Error Codes
Stacker Lower Tray Failure - H5-81 Eject Clamp SNR ON
Stacker Lower Tray Failure - H5-82 Eject Clamp SNR OFF
8
Test the Punch Move Motor.
Run the Service Diagnostics Front and
Rear Punch Move Motor tests.
Does the Punch Move Motor rotate and
the Punch frame move?
Replace the
Finisher Main
PWB
(
page 3-248).
Go to Step 9.
9
Check Punch Motor Harness connections.
Are P/J8344 and P/J8306 connected?
Go to Step 11. Connect and go
to Step 10.
10
Print a Test Print.
Does the error still occur?
Go to Step 11. Problem solved.
11
Check Punch Motor Harness continuity.
1. Disconnect P/J8344 and P/J8306.
2. Check for continuity at the following:
P/J8344-1 <=> P/J8306-7
P/J8344-2 <=> P/J8306-3
P/J8344-3 <=> P/J8306-6
P/J8344-4 <=> P/J8306-5
P/J8344-5 <=> P/J8306-2
P/J8344-6 <=> P/J8306-1
Are these conductive?
Go to Step 12. Repair the Punch
Motor Harness.
12
Replace the Punch Move Motor.
Punch a Test Print.
Does the error still occur?
Go to Step 13. Problem solved.
13
Replace the Finisher Main PWB.
Does the error still occur?
Replace the
Finisher Main
PWB
(
page 3-248).
Problem solved.
Punch Failure (Punch Move Home Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No

Fuji Xerox Phaser 5500 Specifications

General

Brand	Fuji Xerox
Model	Phaser 5500
Category	Printer
Language	English