Fuji Xerox Phaser 5500 User Manual

4-10 Phaser 5500 Printer Service Manual
Print Engine Troubleshooting
Inoperative Printer
No response from printer when the main power is switched on.
Initial Actions
Eliminate the possibility that an installed option is the cause of the problem.
1. Power Printer Off.
2. Unplug all installed options (Finisher, 1000-Sheet Feeder, 2000-Sheet Feeder,
Duplex and Exit 2.
3. Power the printer On. If printer powers up normally, plug in the options one at a
time until the defective option is isolated. If the printer remains inoperative, use
the following procedure to locate the problem.
Inoperative Printer Troubleshooting Reference
Applicable Parts References
■ Power Cord
■ GFI Breaker
■ AC Accessory Panel
■ Wall Outlet
■ Print Engine Electrical Specifications (page 1-13)
■ AC Accessory Panel Plug/Jack Locator (page 10-15)
■ PL8.1 Print Engine Electrical (page 9-40)
Inoperative Printer Troubleshooting Procedure
Step Actions and Questions Yes No
1
Check the AC Power Cord.
Is the AC Power Cord plugged into the
printer and the AC outlet?
Is the GFI breaker operational?
Go to Step 2. Plug in the AC
Power Cord or
reset the GFI
Breaker
2
Check the voltage at the AC outlet.
Is there approximately 110V (or 220V if a
220V model) at the AC outlet?
Go to Step 3. Notify customer
that the power is
out of
specification.
3
Check the AC input Voltage to the LVPS
1. Remove the Upper Right Cover.
2. Power the Printer on.
3. Measure AC voltage at the following test
points on the LVPS.
T 11 –1 <=>T 12 –1 + 120V or 220 V
Are the voltages within specification?
Go to Step 4. Go to Step 5.

Fuji Xerox Phaser 5500 Specifications

General

Brand	Fuji Xerox
Model	Phaser 5500
Category	Printer
Language	English