Fuji Xerox Phaser 5500 User Manual

3-122 Phaser 5500 Printer Service Manual
4
Check Eject Clamp Motor Main Drive
Harness continuity.
1. Disconnect P/J8339 and P/J8304.
2. Check for continuity at the following:
P/J8339-1 <=> P/J8304-33
P/J8339-2 <=> P/J8304-31
Are these conductive?
Go to Step 5. Repair the Main
Drive Harness.
5
Replace the Eject Clamp Motor.
Print a Test Print.
Does the error still occur?
Replace the
Finisher Main
PWB
(
page 3-248).
Problem solved.
6
Test the Eject Motor.
Run the Service Diagnostics Eject Motor
Low Speed Forward test.
Does the Eject Motor rotate forward?
Go to Step 13. Go to Step 7.
7
Check Eject Motor Main Drive Harness
connections.
Are P/J8336 and P/J8304 connected?
Go to Step 9. Connect and go
to Step 8.
8
Print a Test Print.
Does the error still occur?
Go to Step 9. Problem solved.
9
Check Eject Motor Main Drive Harness
continuity.
1. Disconnect P/J8336 and P/J8304.
2. Check for continuity at the following:
P/J8336-1 <=> P/J8304-15
P/J8336-2 <=> P/J8304-12
P/J8336-3 <=> P/J8304-17
P/J8336-4 <=> P/J8304-19
P/J8336-5 <=> P/J8304-14
P/J8336-6 <=> P/J8304-21
Are these conductive?
Go to Step 10. Repair the Main
Drive Harness.
10
Check Eject Motor resistance.
Is there some amount of resistance
across P8336-2/5(COM) <=> P8336-1/3/
4/6?
Go to Step 11. Replace the Eject
Bracket Assembly
(
page 3-187).
11
Check for +24 V to the Eject Motor.
Is there +24 V across J8304-12 <=>
ground, and J8304-14 <=> ground on
the Finisher Main PWB?
Go to Step 12. Replace the
Finisher Main
PWB
(
page 3-248).
12
Replace the Eject Motor.
Print a Test Print.
Does the error still occur?
Replace the
Finisher Main
PWB
(
page 3-248).
Problem solved.
Static Jam at H (No Paper Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No

Fuji Xerox Phaser 5500 Specifications

General

Brand	Fuji Xerox
Model	Phaser 5500
Category	Printer
Language	English