EasyManuals Logo

Fuji Xerox Phaser 5500 User Manual

Fuji Xerox Phaser 5500
623 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #229 background image
Error Messages, Codes, and Procedures 3-151
4
Check for +5 V to the OCT Position Sensor.
Is there +5 V across P/J434-1 (Exit 2) or
P/J432-1 (Exit 1) (+) <=> ground?
Replace the
affected OCT
Position Sensor.
Go to Step 5.
5
Check the connection between the Exit
PWB and the Engine Logic Board.
Are P/J431 and P/J421 connected?
Go to Step 6. Connect P/J431
and P/J421. If
problem persists,
go to Step 6.
6
Check continuity between the Exit PWB
and the Engine Logic Board.
1. Disconnect P/J431 and P/J421.
2. Check for continuity at the following:
P/J431-1 <=> P/J421-8
P/J431-2 <=> P/J421-7
P/J431-3 <=> P/J421-6
P/J431-4 <=> P/J421-5
P/J431-5 <=> P/J421-4
P/J431-6 <=> P/J421-3
P/J431-7 <=> P/J421-2
P/J431-8 <=> P/J421-1
Are these conductive?
Go to Step 7. Repair the wiring.
7
Check the connection between the Exit
PWB and the LVPS.
Are P/J430 and P/J526 connected?
Go to Step 8. Connect P/J430
and P/J526. If
problem persists,
go to Step 8.
8
Check continuity between the Exit PWB
and the LVPS.
1. Disconnect P/J430 and P/J526.
2. Check for continuity at the following:
P/J430-3 <=> P/J526-6
P/J430-4 <=> P/J526-5
P/J430-1 <=> P/J526-8
P/J430-2 <=> P/J526-7
Are these conductive?
Go to Step 9. Repair the wiring.
9
Check for +24 V to the Exit PWB.
Is there +24 V across P/J430-1 (+) <=>
ground?
Replace the Exit
PWB (
page 8-88).
Replace the
LVPS
(
page 8-92).
10
Test the Offset Motor.
Run the Service Diagnostics Offset Output
Motor tests for the appropriate Exit.
Does the Offset Motor operate
properly?
Replace the Exit
PWB (
page 8-88).
If problem
persists, replace
the Engine Logic
Board
(
page 8-89).
Go to Step 11.
11
Check the affected Offset Motor
connection. Exit 1 P/J432 <=> J206 or Exit
2 P/J433 <=> J207.
Is the motor connected?
Go to Step 12. Connect the
motor. If problem
persists go to
Step 12.
Exit Offset Error (OCT Position Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox Phaser 5500 and is the answer not in the manual?

Fuji Xerox Phaser 5500 Specifications

General IconGeneral
BrandFuji Xerox
ModelPhaser 5500
CategoryPrinter
LanguageEnglish

Related product manuals