Fuji Xerox Phaser 5500 User Manual

3-246 Phaser 5500 Printer Service Manual
6
Check Door G Interlock Harness continuity.
1. Disconnect J8365 on the harness,
J8364 on the Eject Cover SW, and
J8388 and J8314 on the Finisher Main
PWB.
2. Check for continuity at the following:
J8365-1A <=> J8388-2
J8365-1B <=> J8364-2
J8365-2A <=> J8314-3
J8365-2B <=> J8314-2
J8364-1 <=> J8388-1
J8364-3 <=> J8314-1
Are these conductive?
Go to Step 7. Repair the
Interlock
Harness.
7
Check +5/+24 V to the Door G Interlock
Switch.
Is there +5 V across J8314-2 <=> ground
on the Finisher Main PWB?
Is there +24 V across J8388-1 <=>
ground on the Finisher Main PWB?
Go to Step 8. Replace the
Finisher Main
PWB
(
page 3-248).
8
Check the Door G Interlock Switch signal.
Does the voltage across J8314-2 <=>
J8314-3 on the Finisher Main PWB
change when the switch is pressed?
Replace the
Finisher Main
PWB
(
page 3-248).
Replace the
Switch
(
page 3-127).
9
Check the Eject Cover Switch.
Does the voltage across J8365-1B <=>
ground on the Door G Interlock Harness
change when the Eject Cover Switch is
actuated?
Go to Step 10. Replace the Door
H Interlock Switch
(
page 3-176).
10
Check the Door G Interlock signal.
Does the voltage across J8388-2 <=>
ground on the Finisher Main PWB
change when the Eject Cover SW and
Door G Interlock Switch are actuated
simultaneously?
Go to Step 11. Replace the Door
G Interlock
Switch.
11
Replace the Finisher Main PWB.
Cycle printer power.
Does the error still occur?
Replace the
Engine Logic
Board
(
page 8-89).
Problem solved.
Door G Open (Door G Interlock Switch) Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No

Fuji Xerox Phaser 5500 Specifications

General

Brand	Fuji Xerox
Model	Phaser 5500
Category	Printer
Language	English