GE HEALTHCARE
DIRECTION 2286865, REVISION 14 LOGIQ™ 7 SERVICE MANUAL
8-14 Section 8-2 - Software Loading Procedures for BT09 (R8.x.x or later)
8-2-7 Install Base System
1.) Power OFF the scanner, wait more than 5 seconds, then power ON the scanner.
2.) Open the DVD drive and set the Ghost DVD.
DVD drive reads Ghost DVD automatically and go to next step.
3.) After loading software, when the following screen appears, press the Enter key.
NOTICE
Before starting to install base system, all printer must be disconnected from the system.
Figure 8-64 Enter
To Next Page
Loading...
Need help?
General
