GE HEALTHCARE
DIRECTION 2286865, REVISION 14 LOGIQ™ 7 SERVICE MANUAL
Section 4-2 - General Procedure 4-7
4-2-3 Power Shutdown
Purpose: This is a description on how to Shutdown the system.
4-2-3-1 Complete Power Down
1.) Press the ON/OFF
key at the front of the System for about two (2) seconds. Refer to Figure 4-2.
2.) Switch OFF the Main Circuit Breaker at the rear of the system Refer to Figure 4-1.
3.) Disconnect the Main Power Cable if needed. Refer to Figure 4-1.
4-2-4 System Stand-by
LOGIQ 7 is available with Stand-by option. The option is effective in reducing the scanner power up
time, when used as portable device.
Users must follow the procedures in order to use the option.
NOTE: Do not use more than 20 Stand-by mode continuously without shutting down the system. The
scanner must be powered off daily.
1.) Press the POWER switch once.
2.) Select Standby.At this point, both the touch panel and the main monitor will go blank. Keyboard
lights also turns dark. Power switch button will be illuminated.
3.) Wait more than 20seconds.
4.) Plug off the power cord from wall outlet.
5.) Transport the scanner as required, but re-connect to power outlet within 20 minutes. If not powered
system may shut down due to loss of sustained battery power.
6.) Connect the scanner to a wall electrical outlet.
Figure 4-10 Selecting Standby
NOTICE
Do not disconnect the power cable immediately.
NOTICE
Do not press the Power button without connecting the power cable.
Standby
To Next Page
Loading...
Need help?
General
