7-8 Chapter 7
Dx20/Dx30 Front Panel LCD Codes
Major Code Category 3: Processor Dependent
Hardware (PDH) Codes
Table 7-5 Processor Dependent Hardware (PDH) Codes
Ostat Code Description
TEST 3000 Start checksuming the FEPROM
FLT 3000 FEPROM checksum failure
INIT 3000 FEPROM checksum correct
TEST 3001 Testing PDH control register
INIT 3001 Initialize the PDH control register
FLT 3001 PDH control register failure
TEST 3002 Scratch RAM under test
INIT 3002 Scratch RAM successfully initialized
FLT 3002 Fatal fault in scratch RAM
WARN 3003 Error reading stable storage, contents are invalid
FLT 3003 Fault reading stable storage and no console present
WARN 3004 Error writing to the EEPROM
FLT 3004 Fatal fault writing to the EEPROM
FLT 3005 Write limit exceeded
WARN 3006 Error reading EEPROM
INIT 3007 Entering LDB
FLT 3008 Invalid system board byte
FLT 3009 Invalid system mode byte
TEST 300B Testing PDH I/O control register
INIT 300B Initialize the PDH I/O control register
FLT 300B PDH I/O control register fault
TEST 301B Model string check
WARN 301B Model string did not match calculated value
FLT 301B Fatal error while checking model string
TEST 301C Checking software ID
INIT 301C Performed software ID update
To Next Page
Loading...
Need help?
General