HP 9000 Series Service Manual

12-14 Chapter 12
Remote Management/Access Port Card
Access Port Commands
Entry to the Access Port (AP) commands is via the ctrl + B function, with the Service/Normal switch
in the
Service
position.
Table 12-4 Access Port Commands
Command Description Remarks
CA Configure command for the Access Port Internal/external modem port, system
identification, bit rate, protocol, and
allows selection of HP or Non-HP
console
CO Enter console mode
CS Copy screen from local to remote
console terminal
DI Disconnect line to remote console
terminal
DR Disable access by a remote console
terminal
Enable session mode access
DS Disable display of system status line
ER Enable access by a remote console
terminal
Disable session mode access
ES Enable display of system status line
HE Display AP commands
LR Lock remote Disable modem access
MS Displays modem status Hit return to stop
RS* Reset system, initiates SPU selftest,
stops processing
Starts software load from load device if
autoboot enabled
SE Transfers remote terminal from
console/control to session mode
SL Displays last 50 chassis codes
SO Sets the security level Requires a PASSWORD (Call the
Response Center for the password).
TA Initiates ap selftest
TC* Transfer of control Retains memory status
TE Sends message between the remote and
local consoles
UR Unlock remote Enable modem access

HP 9000 Series Specifications

General

Brand	HP
Model	9000 Series
Category	Server
Language	English