Invalid port(s) specified as links-to-monitor.
• When a user specifies an invalid LtD port, a message similar to the following is displayed.
Invalid port(s) specified as links-to-disable.
• When a user specifies an incorrect delay value, an error message similar to the following is displayed:
Delay specified does not match with the configured value of <delay value>.
Basic USB port commands
NOTE: The USB port is available only on the 2930M Switch Series.
usb-port
Syntax
usb-port
no usb-port
Description
Enables the USB port.
The no form of the command disables the USB port and any access to the device.
Command context
Config
show usb-port
Syntax
show usb-port
Description
Displays the status of the USB port. It can be enabled, disabled, or not present.
Command context
operator
Usage
One of the following messages indicates the presence or absence of a USB device:
• Not able to sense device in USB port
• USB device detected in port
• no USB device detected in port
Example
Display USB port status.
104 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General