DHCPv6 event messages
Cause
Events Debug messages
When the BST becomes full, to indicate that lease
bindings are being dropped.
Unable to add binding for %x, %02x%02x%02x-%02x
%02x%02x on port %s. BST is full.
When DHCPv6 packet validation fails (packets are
received on which they are not expected to).
Dropping packet as validation failed, reason %s
When a Dynamic binding is replaced with a static
binding on a particular port.
The dynamic binding for %s on port %s was replaced
with a manual binding.
While an attempt to release an Ipv6 address from port
which is leased to another port.
Unable to release. %02x%02x%02x-%02x%02x%02x
is bound not bound to port %u.
Decline from client to server when client finds the
address issued by server is already in use in the link
where the client is connected.
%s: Decline offer from %x (server)of %x because the
address is already assigned to another client.
Decline from client when server assigns an illegal Ipv6
address.
%s: Decline offer from %x (server) of %x because the
address is illegal.
When TFTP transfer of binding state table is a success
or failure.
TFTP of BST from the dsnoopv6 device is successful /
failed.
When a DIPLDv6 enabled port is removed from a
DsnoopV6 enabled vlan.
Port %u is removed from a dhcpv6-snooped VLAN
When DsnoopV6 is disabled globally which makes
DIPLDv6 no longer configured?
Dhcpv6-snooping disabled globally, dynamic Ipv6
lockdown also disabled.
When DsnoopV6 is disabled on a particular VLAN
which makes DIPLDv6 also disabled
Dhcpv6-snooping disabled on VLAN %s, dynamic Ipv6
lockdown also disabled.
When a port moved from SAVI-Trust to validating port. Port %u is validating.
While adding a port to a trunk for which DIPLDv6 is
already enabled.
Unable to add port %u to trunk, dynamic ipv6 lockdown
is enabled on it.
While enabling DIPLDv6 on a port which is added to a
trunk.
Unable to configure dynamic Ipv6 lockdown on port %u
which is a part of a trunk.
While enabling DIPLDv6 on a port for which ACL is
configured.
Unable to configure dynamic Ipv6 lockdown on port
%u, ACL is configured on port.
When it is unable to add a lock on a particular VLAN
for a particular port due to vlan deny rule.
Access was denied on VLAN %d, deny rule exists on
the VLAN
Table Continued
Chapter 9 DHCPv6 server 291
To Next Page
Loading...
Need help?
General