System Name : Switch
System Contact :
System Location :
MAC Age Time (sec) : 300
Time Zone : 0
Daylight Time Rule : None
Software revision : T.13.XX Base MAC Addr : 001635-b57cc0
ROM Version : XX.12.12 Serial Number : LP621KI005
Up Time : 51 secs Memory - Total : 152,455,616
CPU Util (%) : 3 Free : 100,527,264
IP Mgmt - Pkts Rx :0 Packet - Total : 6750
Pkts Tx :0 Buffers Free : 5086
Lowest : 5086
Missed : 0
Collecting processor data with the task monitor (CLI)
The task monitor feature allows you to enable or disable the collection of processor utilization data. The task-
monitor cpu command is equivalent to the existing debug mode command taskusage -d.
When the task-monitor command is enabled, the show cpu command summarizes the processor usage by
protocol and system functions.
Syntax:
[no] task-monitor cpu
Allows the collection of processor utilization data.
Only manager logins can execute this command.
The settings are not persistent, that is, there are no changes to the configuration.
(Default: Disabled)
The task-monitor cpu command and show cpu output
switch(config)# task-monitor cpu
switch(config)# show cpu
2 percent busy, from 2865 sec ago
1 sec ave: 9 percent busy
5 sec ave: 9 percent busy
1 min ave: 1 percent busy
% CPU | Description
-------+-----------------
99 | Idle
task-monitor cpu
Syntax
[no] task-monitor cpu
Description
378 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General