blink <1–1440>
Blinks the chassis locate LED for a specified number of minutes (Default: 30 min.)
on <1–1440>
Turns the chassis locate LED on for a specified number of minutes (Default: 20 min.)
off
Turns the chassis locate LED off.
Chassislocate at startup
The chassislocate command has an optional parameter that configures it to run in the future instead of
immediately.
Syntax
chassislocate [on|blink] <MINUTES> at [now|startup]
chassislocate off
Parameters and options
<MINUTES>
Specify the number of minutes for the chassis locate LED to remain on or blink.
at
Specify when the command is applied (default immediately.)
now
Turn on the chassis locate LED immediately.
startup
Turn on the chassis locate LED at switch startup.
off
Turn off the chassis locate LED switch
chassislocate at startup
chassislocate blink 10 at startup
show system chassislocate
Syntax
show system chassislocate
Description
Displays the current status of the chassislocate settings.
Display locator LED status
Locator LED Status
Current Time
Member State Remaining Configuration
------ ------- --------- -------------
1 blink 00:27:05 blink 30 at startup
376 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General