CAUTION:
Restricting access to only version 3 messages will make the community named “public” inaccessible
to network management applications (such as autodiscovery, traffic monitoring, SNMP trap
generation, and threshold setting) from operating in the switch.
Enabling and disabling switch for access from SNMPv3 agents
This includes the creation of the initial user record.
Syntax:
[no] snmpv3 enable
Enabling or disabling restrictions to access from only SNMPv3 agents
When enabled, the switch rejects all non-SNMPv3 messages.
Syntax:
[no] snmpv3 only
Enabling or disabling restrictions from all non-SNMPv3 agents to read-only access
Syntax:
[no] snmpv3 restricted-access
Viewing the operating status of SNMPv3
Syntax:
show snmpv3 enable
Viewing status of message reception of non-SNMPv3 messages
Syntax:
show snmpv3 only
Viewing status of write messages of non-SNMPv3 messages
Syntax:
show snmpv3 restricted-access
Enabling SNMPv3
The snmpv3 enable command allows the switch to:
• Receive SNMPv3 messages.
• Configure initial users.
• Restrict non-version 3 messages to "read only" (optional).
186 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General