Usage
job <JOB NAME> at <([DD:]HH:]MM on <WEEKDAY-LIST>)> config-save <COMMAND> count <1-1000>
job <JOB NAME> at <[HH:]MM on [MM/]DD> config-save <COMMAND> count <1-1000>
job <JOB NAME> at <EVENT> config-save <COMMAND>
job <JOB NAME> delay <([DD:]HH:]MM> config-save <COMMAND> count <1-1000>
job <JOB NAME> enable | disable
[no] job <JOB NAME>
Show job
Syntax
show job
Description
Show the jobs scheduled.
Show job
switch# show job
Job Scheduler Status and Configuration
Scheduler Status : Waiting for the system time to be set
Event or Repeat Save
Name Time Count Cfg Command
------------------ ---------------- ------- ---- ------------
Burrrrrrrrrrrr... reboot -- Yes chassislocate blink
baz reboot -- No show time
foo 17:00 SxTWTxS -- No savepower led
a1 12:00 2 Yes sh time
a2 Every 2:14:30 days 75 Yes vlan 3
a3 Every 00:00:25 days 1 No vlan 4
NOTE: Caution
The scheduler does not run until the system time is set.
Show job <Name>
Syntax
show job JOB NAME
Description
Show the job by name.
552 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General