Displaying the global and per-port information available for outbound advertisements
switch(config)# show lldp info local-device
LLDP Local Device Information
Chassis Type : mac-address
Chassis Id : 00 23 47 4b 68 DD
System Name : Switch1
System Description : J9091A Switch 3500yl, revision XX.15.06...
System Capabilities Supported:bridge
System Capabilities Enabled:bridge
Management Address
1
Type:ipv4
Address:
LLDP Port Information
Port | PortType PortId PortDesc
----- + --------- ------- ---------
1 | local 1 1
2 | local 2 2
3 | local 3 3
4 | local 4 4
5 | local 5 5
1
The Management Address field displays only the LLDP-configurable IP addresses on the switch. (Only manually-
configured IP addresses are LLDP-configurable.) If the switch has only an IP address from a DHCP or Bootp
server, then the Management Address field is empty (because there are no LLDP-configurable IP addresses
available.
The default per-port information content for ports 1 and 2
switch(config)# show lldp info local 1-2
LLDP Local Port Information Detail
Port : 1
PortType : local
PortId : 1
PortDesc : 1
----------------------------------------
Port : 2
PortType : local
PortId : 2
PortDesc : 2
Displaying the current port speed and duplex configuration on a switch port
You can compare port speed and duplex information for a switch port and a connected LLDP-MED endpoint for
configuration mismatches by using an SNMP application. You can also use the switch CLI to display this
information, if necessary. The show interfaces brief <port-list> and show lldp info remote-
device [port-list] commands provide methods for displaying speed and duplex information for switch
ports. For information on displaying the currently configured port speed and duplex on an LLDP-MED endpoint,
see
Viewing the current port speed and duplex configuration on a switch port on page 244.
Chapter 7 Configuring for Network Management Applications 243
To Next Page
Loading...
Need help?
General