Run Count : 0
Error Count : 0
Skip Count : 0
Command : cfg_rollback
switch(config)# show cfg-restore status
Status : Success
Config File Name : stable
Source : Flash
Time Taken : 9 Seconds
Last Run : Tue Nov 28 20:50:00 2017
Recovery Mode : Enabled
Failure Reason : -
Number of Add Commands : 27
Number of Remove Commands : 0
Time Taken for Each Phase :
Calculating diff : 4 Seconds
Adding commands : 1 Seconds
Removing commands : 0 Seconds
NOTE: If the configuration involves any sensitive information, backup and restore the
configuration by enabling the include-credentials command.
Commands used in switch configuration restore without
reboot
cfg-backup
Backs up the selected configuration to the flash file.
show config files details
Shows a detailed list of configuration files available in the flash.
cfg-restore
Restores the given configuration as the running configuration without reboot.
show cfg-restore status
Shows the status of latest restore performed.
show cfg-restore latest-diff
Views the list of configuration changes that are removed, modified, or added to the running configuration.
show hash
Shows the SHA ID of a startup or running configuration.
Configuration backup
The configuration backup creates a backup of the running or startup configuration of ArubaOS-Switch on-demand
to the flash storage on the switch. The maximum number of backup files supported has increased from three to
five.
NOTE: When you downgrade configuration backup files from five to three, and if the current number
of files is either a four or five, an error message Configuration file <name> stored in
config index 5 is not supported in lower image versions is displayed.
Chapter 15 Configuration backup and restore without reboot 557
To Next Page
Loading...
Need help?
General