Configuring (enabling or disabling) the TimeP mode
Enabling the TimeP mode means to configure it for either broadcast or unicast mode. Remember to run TimeP as
the switch's time synchronization protocol, you must also select TimeP as the time synchronization method by
using the CLI timesync command.
Syntax:
timesync timep
Selects TimeP as the time synchronization method.
Syntax:
ip timep {<dhcp | manual>}
Enables the selected TimeP mode.
Syntax:
[no] ip timep
Disables the TimeP mode.
Syntax:
[no] timesync
Disables the time protocol.
Enabling TimeP in manual mode (CLI)
Like DHCP mode, configuring TimeP for manual mode enables TimeP. However, for manual operation, you must
also specify the IP address of the TimeP server. (The switch allows only one TimeP server.)
Syntax:
timesync timep
Selects TimeP.
Syntax:
ip timep manual <ip-addr>
Activates TimeP in manual mode with a specified TimeP server.
Syntax:
no ip timep
Disables TimeP.
Enabling TimeP in DHCP Mode
Because the switch provides a TimeP polling interval (default:720 minutes), you need only these two commands
for a minimal TimeP DHCP configuration:
Syntax:
timesync timep
Chapter 2 Time Protocols 31
To Next Page
Loading...
Need help?
General