Viewing a MAC-based mirroring session
After you configure a MAC-based mirroring session (Figure 57: Configuring a MAC-based mirroring session
on page 421), you can enter the show monitor 3 command to verify the configuration (Figure 58: Displaying
a MAC-based mirroring session on page 421.)
Figure 57: Configuring a MAC-based mirroring session
Figure 58: Displaying a MAC-based mirroring session
Viewing a local mirroring session
When used to display the configuration of a local session, the show monitor command displays a subset of the
information displayed for a remote mirroring session.
Example
Figure 59: Displaying the configuration of a local mirroring session on page 421 displays a local mirroring
configuration for a session configured as follows:
• Session number: 1
• Session name: Detail
• Classifier-based mirroring policy, "MirrorAdminTraffic", is used to select inbound traffic on port B1.
• Mirrored traffic is sent to exit port B3.
Figure 59: Displaying the configuration of a local mirroring session
Chapter 12 Monitoring and Analyzing Switch Operation 421
To Next Page
Loading...
Need help?
General