running-config-change
Traps for running config change.
snmp-authentication [extended |
standard]
Select RFC-1157 (standard) or ICF-SNMP (extended)
traps.
Startup-config-change
Traps for changes to the startup configuration.
vsf
Enable traps for the VSF functionality.
To determine the specific cause of a security event, check the Event Log in the console interface to see why a
trap was sent. For more information, see "Using the Event Log for Troubleshooting Switch Problems".
Viewing the current configuration for network security notifications (CLI)
Enter the show snmp-server traps command, as shown in the following example. Note that command output
is a subset of the information displayed with the show snmp-server command in
Display of SNMP
notification configuration.
Display of configured network security notifications
switch(config)# show snmp-server traps
Trap Receivers
Link-Change Traps Enabled on Ports [All] : A1-A24
Traps Category Current Status
------------------------------ --------------------------
SNMP Authentication : Extended
Password change : Enabled
Login failures : Enabled
Port-Security : Enabled
Authorization Server Contact : Enabled
DHCP Snooping : Enabled
Dynamic ARP Protection : Enabled
Dynamic IP Lockdown : Enabled
Address Community Events Sent Notify Type Retry Timeout
---------------------- ---------- ----------- ----------- ----- -------
15.255.5.225 public All trap 3 15
2001:0db8:0000:0001
:0000:0000:0000:0121 user_1 All trap 3 15
Excluded MIBs
Enabling Link-Change Traps (CLI)
By default, a switch is enabled to send a trap when the link state on a port changes from up to down (linkDown) or
down to up (linkUp). To reconfigure the switch to send link-change traps to configured trap receivers, enter the
snmp-server enable traps link-change command.
Syntax:
[no] snmp-server enable traps link-change <port-list> [all]
Enables or disables the switch to send a link-change trap to configured trap receivers when the link state on a
port goes from up to down or down to up.
204 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General