Remote Device Deployment (TR-069)
Introduction
TR-069 is a technical specification created by the Broadband Forum. The TR-069 protocol specifies client and
server requirements to manage devices across the Internet by using a client server architecture to provide
communication between the CPE (Customer Premises Equipment) and the ACS (Auto Configuration Server). A
protocol helps to manage complex networks where many devices such as modems, routers, gateways, VoIP
phones and mobile tablets compete for resources. TR-069 defines the CPE WAN Management Protocol (CWMP)
protocol necessary to remotely manage end-user devices. ACS provides automatic configuration for these
devices.
NOTE: CWMP is automatically enabled. To conserve resources, reconfigure this setting using the
cwmp disable command.
TR-069 defines an auto-configuration architecture which provides the following primary capabilities:
• Auto-configuration and dynamic service provisioning
• Software/firmware image management
• Status and performance monitoring
• Diagnostics
• Bidirectional SOAP/HTTP based protocol
Appendix B
Remote Device Deployment (TR-069)
752 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General