CAUTION: To avoid broadcast storm or loops in your network while configuring ZTP, do not have
redundant links after you complete ZTP and Airwave registration. Authorize the new switch and then
push the Golden Configuration template from Airwave.
Example
Enable Aruba Central server support
switch(config)# aruba-central enable
Disable Aruba Central server support
switch(config)# aruba-central disable
Enter support mode to enable all CLI configuration commands
switch(config)# aruba-central support-mode enable
This mode will enable all CLI configuration commands, including those normally reserved by the Aruba Central
service.
Use of this mode may invalidate the configuration provisioned through Aruba Central server.
Continue (y/n)?
Troubleshooting
You can troubleshoot switches by using the SSH connection and the device logs available in AirWave. For a list of
all RMON message, refer to Event Log Messages Guide of your switch
You can enable the debug logging with the debug ztp command, see debug ztp .
Show aruba-central
Syntax
show aruba-central
Description
Shows Aruba Central server information.
Example
switch#show aruba-central
Configuration and Status - Aruba Central
Server URL : https://internal.central.arubanetworks.com/ws
Connected : Yes
Mode : Managed
Last Disconnect Time : NA
Server DNS Lookup : Success
Proxy Server DNS Lookup : NA
Error Reason : NA
Chapter 10 Zero Touch Provisioning with AirWave and Central 331
To Next Page
Loading...
Need help?
General