LED 1 displays slow flash orange and LED 2 displays solid green color, whereas, LED 3
displays different colors
Symptom
LED 1 displays slow flash orange and LED 2 displays solid green color. LED 3 displays slow flash green, fast
flash green, or slow flash orange.
1
1
LED 1 is Global Status LED, LED 2 is Mode LED Usr, and LED 3 is Port LED.
Cause
A stack link failure has occurred in a chain topology and multiple stack fragments have been created. Each
fragment will elect a Commander, so there will be multiple switches with the Cmd LED on.
Action
1. Repair the cause of the stack link failure.
2. Reconnect the switches in their original topology so that the switches can reform the original stack.
LED 1 and LED 2 display solid green, whereas, LED 3 displays different colors
Symptom
LED 1 and LED 2 display solid green, whereas, LED 3 displays slow flash green and fast flash green.
1
1
LED 1 is Global Status LED, LED 2 is Mode LED Usr, and LED 3 is Port LED.
Cause
Merging two stacks that have different stack IDs which were not previously part of the same stack.
Action
1. Select one of the stacks as the one to retain.
2. Erase the stacking configuration for each switch in the other stack by issuing stacking factory-reset at
the config level. The startup configuration for each switch is erased, including the stacking configuration.
3. Add the switches to the stack as described in the Stack Management chapter of the ArubaOS-Switch
Advanced Traffic Management Guide K/KA/KB.16.01.
704 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General