Filter Delay = 4.23 4.14 2.41 5.95 2.37 2.33 4.26 4.33
Filter Offset = -8.59 -8.82 -9.91 -8.42 -10.51 -10.77 -10.13 -10.11
show ntp authentication
Syntax
Description
Show the authentication status and other information about the authentication key.
show ntp authentication
Switch(config)# show ntp authentication
NTP Authentication Information
Key-ID Auth Mode Trusted
-------- ---------- -------
67 md5 yes
7 md5 no
1 sha1 yes
2 sha1 no
Validation rules
Validation Error/Warning/Prompt
If access-list name is not valid. Please enter a valid access-list name.
If the authentication method is being set to
two-factor authentication, various messages
display.
If both the public key and username/password are not
configured: Public key and username/password should
be configured for a successful two-factor
authentication.
If public key is configured and username is not
configured:
Username and password should be configured for a
successful two-factor authentication.
If the username is configured and public key is not
configured:
Public key should be configured for a successful two-
factor authentication.
If “ssh-server” certificate is not installed at the time of
enabling certificate-password authentication:
The “ssh-server” certificate should be installed for a
successful two-factor authentication.
If the authentication method is set to two-
factor while installing the public key, a
message displays.
The client public keys without username will not be
considered for the two-factor authentication for the SSH
session.
Table Continued
60 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General