ELECTRICAL SYSTEM
B2650HSDC, B3350HSDC, WSM
8-S38
(14) Governor Solenoid (V1505)
• Do active test "EGV Solenoid Check Function" by using diagmaster before following checking (Refer to
"Diagnosis Manual V1505-T-E4 (9Y120-02490)").
9Y1210822ELS0127US0
Connector Voltage
1. Disconnect the connector, and turn the main key switch "ON"
position.
2. Measure the voltage with a voltmeter across the terminals
shown in the table below.
3. If the reference value is not indicated as shown in the table
below, check the relating electric circuit.
9Y1210822ELS0128US0
Solenoid Resistance
1. Measure the resistance with an ohmmeter across the terminals
shown in the table below.
2. If the reference value is not indicated, the governor solenoid is
faulty.
9Y1210822ELS0129US0
Voltage
Main switch at
"ON"
Terminal 2 –
chassis
Approx. 7.85 V
(1) Governor Solenoid (2) Connector (Harness Side)
Resistance Factory specification
2.52 to 3.08 Ω
at 20 °C (68 °F)
(1) Connector (Solenoid Side)
To Next Page
Loading...
Need help?
General
